How to clean wet carpet in car? Don’t miss this Tips

Rate this post

Want to learn how to clean wet carpet in car?  If yes, then this article is for you. In this article I disscuss in detail on how to clean wet carpet in car. Keep reading….

On a nice day, you leave your car windows open to let the air out, but then forget to close them. When you get to your car the next morning, you discovered that it has rained overnight. Water damage can cause long-term issues and odors, so knowing how to clean wet carpet in car is crucial.

How to clean wet carpet in car?

How to clean wet carpet in car?

In reality, there are numerous reasons for a car’s carpet to become wet. Wet carpet can be caused by storm damage, flood damage, or even DIY car carpet cleaning.

Water damage is a problem in any building, but it’s especially bad in cars. After all, cars are built to keep water out. When the engine isn’t running, they’re enclosed spaces with little ventilation. As if that wasn’t challenging enough, a car’s carpet lining isn’t removable; only the floor mats can be removed to dry. So, you need to know how to clean wet carpet in car.

In an ideal world, you’d be able to put off dealing with the wet carpet for a few days. The reality is that water damage must be cleaned as soon as possible. Mold, mildew, and strange odors can take hold in just a few hours.

1– Tools and Equipments

In order to learn how to clean wet carpet in car,  you need following tools and ingredients.

  • Covered area for your car to dry.
  • Shop vac.
  • Towels, washcloths, or shop towels.
  • Fan (or fans)
  • Baking soda (optional but recommended)

2– Step to clean wet carpet in car

  1. To avoid more water getting in, move the car to a covered area, such as a garage, carport, or under a tarp.
  2. Open all of the doors and windows, as well as the trunk if it is affected. To avoid battery drain, you might want to consider disconnecting your battery.
  3. Remove the floor mats and, if applicable, the trunk mat. If your trunk is flooded, you might want to remove the spare tire cover, jack, and spare tire while the area dries out. Allow these to air dry.
  4. Remove as much excess water from your car’s cabin as possible with a shop vac. If necessary, repeat on the floor mats and in the trunk.
  5. Using towels, soak up any excess liquid.
  6. After that, you’ll want to start moving the air around. Excess humidity in your vehicle is the last thing you want to happen. To keep the air circulating, position a large fan – or fans, if you have them – into the vehicle. Leave the fan on all night if possible. Depending on how wet the area is, you might need to let the car dry for a full day.
  7. In the car, keep a box of refrigerator-safe baking soda. This will absorb any remaining moisture while also deodorizing the vehicle.

3– Dry the foam underneath

When the carpet in your car gets wet, the water seeps beneath it and straight to the foam backing. If the foam remains wet for a long time, mildew will grow on it, making it nearly impossible to remove later. (#tags– how to clean wet carpet in car)

To begin, prop up the sill with a screwdriver to gain access to the foam. To create an air pocket, you’ll need something firm and sturdy, such as a brick or a wooden plank.

You might even have to pry off a plate along the bottom edge of your car to get to the sill. However, if you still can’t reach it, you may need to remove the seats to see the sill.

Take your fan and point it at the foam once you’ve gained access to it. Again, it may take a few days to completely remove all of the moisture.

I recommend using the DampRid Bags for extra moisture protection. To absorb moisture in your car, hang these bags on the handles above car doors or on the headrests.

If you can’t find the DampRid Bags, you can always use baking soda instead. To get the full effect, simply scatter a few opened boxes or jars of baking soda around your vehicle. (#tagshow to clean wet carpet in car)

4– Keep the mildew out

Use a water and vinegar solution on your carpet if you can already smell mildew growing in your vehicle. For easier application, pour it into a spray bottle and set aside for 20 minutes. Then, using a brush, scrub the solution and wipe it clean with a dry towel or cloth.

Instead of vinegar, you could use dishwashing soap or even tea tree oil if you don’t like the smell. However, do a patch test first to ensure that no stains are left on the carpet.

In this way, you will be able to clean wet carpet in car. Lets share your experience with us.

How to Deodorize a Car After Water Damage?

Deodorize wet carpet in car

It takes time to deodorize a car after it has been flooded, but it is possible. These three suggestions can assist you in getting your car back to normal.

1– Baking Soda and a Vacuum

Sprinkle baking soda over the affected area after your car carpets have dried. Allow for at least half an hour before vacuuming. As needed, repeat.

2– Charcoal Briquettes

Place a large handful of natural charcoal briquettes in a bowl or, if you have one, a berry basket. Pretreated briquettes should not be used. Place this close to the affected area. Allow 2–3 days for the charcoal to decompose in the car. Replacing the charcoal and repeating the process as needed.

3– Professional Cleaning

It may be necessary to have your car professionally shampooed and cleaned in some cases. These services vary in cost, but they can usually get rid of those noxious ‘wet car’ odors.

Although exhausting, cleaning wet carpet in a car is not as difficult as it may appear. All you have to do now is remember to clean thoroughly and dry slowly. You won’t have to worry about mildew spots, and your carpet will last much longer.

Now you know, how to clean wet carpet in car. Leave your comment bellow if you have any kind of problem.

Sharing Is Caring:

Leave a Comment